LTL and FTL shipping Best Practices

LTL and FTL shipping Best Practices | LoadProof

This is another best practice to keep in mind while you’re doing LTL or FTL. We all know that LTL is less than truckload and FTL is full truck load, the full truckload it’s always point A to point B, you load the truck to the fullest and then close it, lock it, and seal it. The loading process should be done carefully with air pillows and load bars/ cargo bars.

If it makes sense to strap, apply the strap, this is all pretty standard for FTL. After you lock it and then seal it, take the picture of the seal with the conditions of the load before closing the door and upload them to LoadProof. Whoever has any question, you can immediately show them the condition of the product when it left your facility, so you can prove you did your job right. In the LTL scenario you’re loading in the last-in, first-out sequence.

You are loading in a reverse top sequence so if you are making 10 stops in a town the last stop goes first that means it’s all the way to the deep end of the trailer and then the next one. The first one is kept at the front, so what happens is the driver goes to the first stop, drops off the first set of pallets and then goes to the second stop and drops off the second.

Click here to continue reading this article.

Comments

Picture Documentation for Freight Claims White Paper – Part I | LoadProof

INTRODUCTION This document describes the benefits of an effective Picture Documentation System(PDS) that helps with getting Freight Claims Paid faster. An effective pictures documentation system helps with 1 – Get Freight Claims paid much faster by making pictures available quickly and easily, 2 – Provides visibility to the damages through pictures. The visibility gained provides insight into the handling mistakes made while the orders are fulfilled, so that the parties can determine and establish accountability boundaries and get the shipper paid. BACKGROUND What are Freight Claims? A freight claim is a legal demand by a shipper or a consignee to a carrier for financial reimbursement for a loss or a damage of a shipment. Freight Claims are claims submitted by manufacturers/suppliers/shippers to transportation vendors and or carriers, when the goods the Supplier shipped did not arrive at the destination in a pristine state. Instead it arrived as damaged, the packaging was damaged...

Optimize Your Warehouse Replenishments with these Best Practices | LoadProof

This best practice is about making replenishments inside the warehouse. It is important to stay on the top off replenishments always in your warehouse. If you have just one shift that you are running it would help a lot. If you spend extra hours in the evening and then do the topping off all your active locations it will be helpful for the pickers in the next shift. In the next morning when the pickers come after all the locations will be full and they can start picking right away without wasting time in replenishments. If you have two shifts running either choose the second shift or have a third shift if possible and keep doing the top off replenishments. There are active replenishment locations and these active locations have Min and Max. Whenever your inventory falls below min, replenishments are going to get triggered or it will get triggered if there is an order that needs a lot of picks from a particular location. This will drive the location down which will tri...

11 Ways to Avoid Retail Chargebacks in Your Supply Chain | LoadProof

What are chargebacks? Chargebacks are fines that retailers impose on suppliers because the Retailers are doing extra work to process the Supplier’s product through the Retailer’s Supply Chain. Why are suppliers getting chargebacks? Because Supplier’s shipments are not fully in compliance with the requirements set by the retailers on how the shipments should be arriving at the Retailer’s distribution center If a supplier is not fully following the compliance requirements, then that needs to be addressed first. So dedicate a person to this activity, there are people called Compliance specialists available that know how to get this right, they have a lot of experience working with specific retailers or you will have to review the routing guide. However a very good chargeback system will show your people the mistakes being made If you are doing everything correctly, then still getting chargebacks, then the chargeback management system will absolutely help you Are you including all th...

Image Enabling The Supply Chain

Search This Blog